Gto Wireless Exit Sensors GTO Instrukcja Użytkownika Pobierz pdf (Strona 2)

Wireless Exit Sensor

Above is a typical location where installing a conventional

“wired” exit sensor would require cutting and trenching

across more than 50 feet of asphalt driveway.

Gate Opener

Receiver

Driveway

Transmitter

100’ Max

Wireless

RANGE:

12 ft. radius

(max)

SENSOR:

2 feet from

driveway (max)

and 12” deep

Open Gate

Outside

Sensor Range

25 ft. from

gate (min)

Sensor and Module Placement Overview

• DeterminetheoptimumlocationfortheVEHICLESENSORusingtheinformationfoundabovein“Sensorand

 TransmitterPlacementOverview”.Thendigaholeapproximately10-12inchesdeepand24incheslongwithin

 2feetandparalleltotheedgeofthedriveway.Next,digatrenchnomorethan15ftfromthisholetothelocation

 whereyouwillinstallthetransmittermodule.KeeptheVEHICLESENSORandthecableuncoveredatthistime.

IMPORTANT: Clear an area 20 feet in all directions of metal tools, toys and automobiles, to prevent magnetic disturbance

during testing and installation.

Sensor Placement

Determining Sensor Location

For Optimum Performance:

•LocatetheSENSORasfaraspossibleawayfrompowertransformers,powerlines,underground

 gasline,andtelephonelines.

•LocatetheSENSORawayfromgeneralmovingtrafctopreventunwantedactivation.Remember

 thattheSENSORdetectsMAGNETICDISTURBANCEScausedbyavehicle’smassandvelocity.

•Rangedistanceisapproximateandwillvaryduetooutsideinterference,typeofsoil,vehiclemass,

 speed,etc.

•ItisrecommendedthatyouruntheSignalCableinsidePVCconduittopreventaccidentaldamage.

•DonotrunSignalCableinconduitwithotherwiressuchasACpowerorothercontrolwires.

•TheSIGNALCABLECANNOTBESPLICED.Ifyouneedmorewire,contacttheGTOSales 

 Departmentat1-800-543-GATE(4283).

NOTE: Place the transmitter on

the same side of the driveway in

the line of sight of the receiver to

maximize the range.

1 2 3 4 5 6 7 8 9

Komentarze do niniejszej Instrukcji

Brak uwag

Gto Wireless Exit Sensors GTO Instrukcja Użytkownika Strona 2

Komentarze do niniejszej Instrukcji